Silverado SS AWD V8-6.0L VIN N (2003)
1. Install the J43484 (2) to the J8092 (1).
2. Install a NEW seal onto J43484.
3. Using J43484 (2), and J8092 (1), install the seal.
4. Install the front propeller shaft.
5. Check the fluid level. Add fluid, if necessary.
6. Install the transfer case shield, if equipped.
Transfer Case Output Shaft Seal Replacement - Rear
Transfer Case Output Shaft Seal Replacement - Rear
Tools Required
^
J37668-A Output Shaft Seal Installer
^
J45380 Transfer Case Rear Bushing Remover and Installer
Removal Procedure
1. Remove the transfer case shield, if equipped.
2. Remove the rear propeller shaft.
3. Pry out the rear output shaft seal, using a flat-tipped screwdriver.