Silverado SS AWD V8-6.0L VIN N (2003)
4. Inspect the rear output shaft bushing for scoring or wear.
5. Remove the rear output shaft bushing if required, using the J45380.
^
Install the finger section of the J45380 into the front of the bushing.
^
Install the tube and forcing screw to the finger section. Ensure the forcing screw is backed out.
^
Using a wrench on the forcing screw, remove the rear output shaft bushing.
Installation Procedure
1. Using the J45380, install a NEW rear output shaft bushing.
^
Install the bushing or the finger section of the J45380.
^
Install the finger section to the main body of the J45380.
^
Position the bushing and tool to the case.
^
Using a hammer and the J45380, install the bushing,
Important: Ensure the drain hole on the boot of the rear output shaft seal is facing down toward the ground.
2. Using the J37668-A, install a NEW front output shaft seal.