Spectrum L4-91.5 1.5L (1985)
Fig. 8 Bearing race installation
8.
Install inner and outer bearing races using tool J-35307-1 and J-35307-2 respectively, Fig. 8.
Fig. 9 Axle seal installation
9.
Install new oil seal in inner side of hub using tool No. J-35305 or equivalent, Fig. 9.
10.
Pack bearings using suitable grease.
11.
Reverse procedure to install, and adjust wheel bearings as follows:
a. Tighten hub nut to 22 ft. lbs.
b. Loosen hub nut, then tighten finger tight.
c. Install retainer, then cotter pin.
