Sprint-Import L3-061 1000cc 1.0L Turbo VIN 2 FI (1987)
Fig. 22 Engine block stamping
ASSEMBLY
Two sizes of pistons are available as standard size spare parts to ensure proper piston-to-cylinder clearance. When installing standard piston, match
piston to its bore as follows:
a. Each piston has number 1 or 2 stamped on top, Fig. 21, to indicate its outside diameter.
b. The engine block is stamped as shown in Fig. 22, to indicate size of piston in each bore.
Fig. 23 Piston to connecting rod installation
Assemble pistons, rings and rods as follows:
1.
Apply engine oil to piston pin bores in piston and rod and fit connecting rod to piston as shown in Fig. 23.
