Sprint-Import L3-061 1000cc 1.0L Turbo VIN 2 FI (1987)
Ignition Control Module: Testing and Inspection
Module Testing
Fig. 5 Checking ignition module
1.
Remove dust cover from module and disconnect red and white wires.
2.
Connect ohmmeter, test lamp, and 12 volt battery as shown in Fig. 5.
3.
Set ohmmeter to 1 - 10 ohm range. Connect negative probe to red wire terminal of module and positive probe to white wire terminal. If test lamp
illuminates, module is satisfactory. If not, replace module. Ohmmeter leads should only be connected as outlined above. Reversing leads may
cause damage to module.
4.
Connect red and white wires to module and install dust cover.