chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

SIR Disabling and Enabling Zones|Page 11426 > < SIR Disabling and Enabling Zones|Page 11424
Page 7
background image

2. Connect the steering wheel module yellow 4-way connector (2) located left of the steering column near the knee bolster.
3. Install the CPA (1) to the steering wheel module yellow 4-way connector (2) located left of the steering column near the knee bolster.

4. Install the SIR fuse to the fuse block (1) located in the underhood fuse block.
5. Staying well away from all air bags, turn ON the ignition, with the engine OFF.

1. The AIR BAG indicator will flash 7 times.
2. The AIR BAG indicator will then turn OFF.

6. Perform the Diagnostic System Check - Vehicle in Vehicle DTC Information, if the AIR BAG indicator does not operate as described.

SIR Disabling and Enabling Zone 5

SIR DISABLING AND ENABLING ZONE 5

DISABLING PROCEDURE

1. Turn the steering wheel until the vehicle's wheels are pointing straight ahead.

IMPORTANT:  Refer to SIR Disabling and Enabling Zones before disabling the SIR system.

2. Turn OFF the ignition.
3. Remove the key from the ignition.
4. Access the inflatable restraint instrument panel (I/P) module connector through glove box.

SIR Disabling and Enabling Zones|Page 11426 > < SIR Disabling and Enabling Zones|Page 11424