SSR V8-6.0L VIN H (2006)
17. Disconnect the LF side impact module yellow 2-way connector (1) located under the driver seat.
18. Remove the lock pillar trim panel.
19. Remove the CPA from the seat belt pretensioner - left connector.
20. Disconnect the seat belt pretensioner - left connector from the vehicle harness connector.
ENABLING PROCEDURE
1. Remove the key from the ignition.
2. Connect the steering wheel module yellow 4-way connector (2) located left of the steering column near the knee bolster.
3. Install the CPA (1) to the steering wheel module yellow 4-way connector located left of the steering column near the knee bolster.
