SSR V8-6.0L VIN H (2006)
the rumbling noise is related to the drive belts or not. With the drive belts removed, the water pump will not operate and the engine may overheat.
Also DTC's may set when the engine is operated with the drive belts removed.
4. Inspect the drive belts to ensure that the drive belts are not the cause of the noise. Small cracks across the ribs of the drive belts will not cause the
noise. Belt separation is identified by the plys of the belt separating. This may be seen at the edge of the belt or felt as a lump in the belt.
5. Small amounts of pilling is a normal condition and acceptable. When the pilling is severe, the drive belts do not have a smooth surface for proper
operation.
Step 1 - Step 8
Drive Belt Squeal Diagnosis
Drive Belt Squeal Diagnosis
Diagnostic Aids
A loose or improper installation of a body, or suspension component, or other items on the vehicle may cause the squeal noise.
If the squeal is intermittent, verify that it is not the accessory drive components by varying their loads, making sure they are operating to their
maximum capacity. An overcharged air conditioning (A/C) system, a power steering system restriction or the incorrect fluid, or a failing generator are
suggested items to inspect.
Test Description
The numbers below refer to the step numbers on the diagnostic table.
2. The squeal may not be engine related. This step is to verify that the engine is making the noise. If the engine is not making the noise do not
