SSR V8-6.0L VIN H (2006)
1. Locate the lever lock on the wire dress cover. While depressing the lock, pull the lever over and past the lock.
2. Disconnect the connector from the component.
3. Locate the dress cover locking tabs at the front of the connector. Using a small flat-blade tool push down on one of the locking tabs and pull the
cover up until the dress cover releases. Repeat this procedure for the other locking tab.
4. Once the front 2 locks are unlocked, lift the front of the dress cover and pull it forward.
5. Remove the TPA by inserting a small flat-blade tool into the small slot on the TPA and pushing down until the TPA releases. Gently pry the TPA
out of the connector.
IMPORTANT: Always use care when removing a terminal position assurance (TPA) in order to avoid damaging it.
6. Insert the J 38125-21 (GM P/N 15381651-2) tool into the round canal between the terminals cavities at the front of the connector. See the release
tool cross reference in the Reference Guide of the J-38125 to ensure that the correct release tool is used.
IMPORTANT: Be careful not to angle or rock the J 38125-21 tool when inserting it into the connector or the tool may break.
7. While holding the removal tool in place, gently pull the wire out of the back of the connector. Always remember never use force when pulling a
terminal out of a connector.
Insert the J 38125-21 (GM P/N 15381651-2) tool into the round canal between the terminals cavities at the front of the connector. See the release tool
cross reference in the Reference Guide of the J-38125 to ensure that the correct release tool is used.
REPAIR PROCEDURE
Follow the steps below in order to repair Micro 64 connector terminals.
