SSR V8-6.0L VIN H (2006)
2. Connect the seat belt pretensioner - right and install the CPA.
3. Install the lock pillar trim panel.
4. Connect the side impact sensor yellow 2-way connector (5) located near the middle of the door.
5. Install the CPA (3) to the side impact sensor yellow 2-way connector (5) located near the middle of the door.
6. Install the right door trim panel.
7. Install the SIR fuse to the fuse block (1) located in the underhood fuse block.
8. Staying well away from all air bags, turn ON the ignition, with the engine OFF.
1. The AIR BAG indicator will flash 7 times.
2. The AIR BAG indicator will then turn OFF.
9. Perform the Diagnostic System Check - Vehicle in Vehicle DTC Information, if the AIR BAG indicator does not operate as described.
SIR Disabling and Enabling Zone 7
SIR DISABLING AND ENABLING ZONE 7
DISABLING PROCEDURE
