SSR V8-6.0L VIN H (2006)
Fuel Pressure: Testing and Inspection
Fuel Pressure Gage Installation and Removal
FUEL PRESSURE GAGE INSTALLATION AND REMOVAL
TOOL REQUIRED
J 34730-1A Fuel Pressure Gage
INSTALLATION PROCEDURE
CAUTION: Refer to Gasoline/Gasoline Vapors Caution in Service Precautions.
1. Remove the engine sight shield.
2. Install the J 34730-1A to the fuel pressure service connection, located on the fuel rail.
CAUTION: Refer to Fuel Gage Leak Caution in Service Precautions.
NOTE: Refer to Fuel and Evaporative Emission (EVAP) Hose/Pipe Connection Cleaning Notice in Service Precautions.
3. Turn ON the ignition.
4. Place the bleed hose of the fuel pressure gage into an approved gasoline container.
CAUTION: Refer to Fuel Storage Caution in Service Precautions.
5. Open the bleed valve on the fuel pressure gage in order to bleed the air from the fuel pressure gage.
6. Command the fuel pump ON with a scan tool.
7. Close the bleed valve on the fuel pressure gage.
8. Inspect for fuel leaks.
REMOVAL PROCEDURE
1. Place the fuel pressure gage bleed hose into an approved container and open the bleed valve to bleed OFF fuel system pressure.
2. Place a shop towel under the J 34730-1A to catch any remaining fuel spillage.
3. Remove the J 34730-1A from the fuel pressure connection.
4. Drain any fuel remaining in the fuel pressure gage into an approved container.
5. Inspect for leaks using the following procedure:
1. Turn ON the ignition, with the engine OFF for 2 seconds.
2. Turn OFF the ignition, for 10 seconds.
3. Turn ON the ignition, with the engine OFF.
4. Inspect for fuel leaks.
6. Install the cap on the fuel pressure connection.
7. Install the engine sight shield.
