SSR V8-6.0L VIN H (2006)
4. Install the fuel rail crossover pipe (3), O-rings (4), retaining bolts (1) and tabs (2), if removed.
Tighten the fuel rail crossover pipe retaining screws to 3.8 N.m (34 lb in).
5. Connect the fuel feed pipe.
6. Reconnect the electrical connectors for the fuel injectors. A click will be felt or heard when the electrical connector is properly connected.
IMPORTANT: Ensure that the fuel injector electrical connector are connected to the correct fuel injector. It may also be necessary to rotate the fuel
injector the proper alignment between the fuel injector and the electrical connector.
7. Position the engine wiring harness on the intake manifold.
8. Connect the EVAP purge valve and harness.
9. Install the engine sight shield mounting bracket.
Tighten the engine sight shield mounting bolts to 5.5 N.m (49 lb in).
10. Connect the negative battery cable.
11. Use the following procedure to inspect for fuel leaks:
