SSR V8-6.0L VIN H (2006)
8. Remove the lock pillar trim panel.
9. Remove the CPA from the seat belt pretensioner - left connector.
10. Disconnect the seat belt pretensioner - left connector from the vehicle harness connector.
ENABLING PROCEDURE
1. Remove the key from the ignition.
2. Connect the seat belt pretensioner - left and install the CPA.
3. Install the lock pillar trim panel.
4. Connect the side impact sensor yellow 2-way connector (5) located near the middle of the door.
5. Install the CPA (3) to the side impact sensor yellow 2-way connector (5) located near the middle of the door.
6. Install the left door trim panel.
