Replacing Battery Positive Cable from Battery to Junction Block in SSR V8-60L VIN H
10. Remove the nut retaining positive cable to starter.
11. Remove the positive cable assembly from wire looms.
12. Remove the positive cable assembly from vehicle from the bottom of the vehicle.
INSTALLATION PROCEDURE
1. Install the positive cable assembly into vehicle from the bottom of vehicle.
2. Install the positive cable assembly to wire looms.
3. Install the nut to retain positive cable to starter.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the nut to 9 N.m (80 lb in).
4. Lower the vehicle.
5. Install the positive cable to rear of generator.
