SSR V8-6.0L VIN H (2006)
6. Lower the vehicle.
7. Disconnect the power steering pressure (1) and return hose (3) from the power steering pump (2).
8. Remove the Powertrain Control Module (PCM) from the PCM mounting bracket and position out of the way.
9. Remove the power steering hose assembly (1) front bracket mounting bolt (3) from the frame.
10. Remove the power steering pressure hose from the retaining clip.
11. Remove the power steering hose assembly rear bracket mounting bolt (2).
12. Remove the power steering hose assembly from the vehicle.
13. Raise and support the vehicle. Refer to Vehicle Lifting.
Notice: Clean the power steering gear inlet and outlet ports thoroughly of any debris. Failure to do so could result in contamination and damage to the
power steering system components.
14. Install the seal extraction end of the J 44586 (2) to the power steering gear oil seal (1).