SSR V8-6.0L VIN H (2006)
6. Remove the connector position assurance (CPA) (3) from the side impact sensor yellow 2-way connector (5) located near the middle of the door.
7. Disconnect the side impact sensor yellow 2-way connector (5) located near the middle of the door.
8. Remove the lock pillar trim panel.
9. Remove the CPA from the seat belt pretensioner - left connector.
10. Disconnect the seat belt pretensioner - left connector from the vehicle harness connector.
ENABLING PROCEDURE
1. Remove the key from the ignition.
2. Connect the seat belt pretensioner - left and install the CPA.
3. Install the lock pillar trim panel.
