Suburban 1/2 Ton 2WD V8-5.3L VIN T (2004)
Rear Bumper Cover / Fascia: Service and Repair
Fascia Replacement - Rear Bumper
Removal Procedure
1. Remove the top fascia retainers.
2. Disconnect the license plate lamp harness.
3. Raise and support the vehicle with suitable safety stands. Refer to Vehicle Lifting.
4. Remove the push-pin retainers from the underside of the fascia.
5. Remove the fascia from the impact bar.
Installation Procedure
1. Align the locator pin of the fascia to the hole in the impact bar.
2. Press the push-pin retainers into the underside of the fascia.
3. Remove the safety stands, and lower the vehicle.
4. Connect the license plate lamp harness.
5. Install the top fascia retainers.
