Suburban 1/2 Ton 2WD V8-5.3L VIN T (2004)
Cowl Moulding / Trim: Service and Repair
Air Inlet Grille Panel Replacement
Removal Procedure
1. Remove the wiper arms.
2. Pull up in order to release the outboard air inlet grille panel clips.
3. Remove the attaching clips running along the edges of the center air inlet grille panel.
4. Remove the sheet metal screws on each end of the air inlet grille panel.
5. Disconnect the windshield washer hose from the nozzle underneath the center air inlet grille panel.
6. Remove the air inlet grille panel.
Installation Procedure
1. Connect the windshield washer hose to the nozzle under the center air inlet grille panel.
2. Position the air inlet grille panel to the vehicle and attach the clips to the edges of the center air inlet grille panel.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the sheet metal screws on each end of the air inlet grille panel.
Tighten the sheet metal screws to 2 N.m (18 lb in).