Suburban 1/2 Ton 2WD V8-5.3L VIN T (2004)
Trunk / Liftgate Shock / Support: Service and Repair
Strut Replacement - Liftgate
Strut Replacement - Liftgate
Removal Procedure
Caution: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the
vehicle or personal injury.
1. Open the liftgate.
2. Support the liftgate.
Notice: Apply pressure only at the end of the liftgate/hood assist rod that you are removing or attaching. Do NOT apply pressure to the middle of
the rod because damage or bending will result.
3. Carefully pry the retaining clip in order to remove the lower end of the liftgate strut (1) from the ball stud on the body.
4. Carefully pry the retaining clip in order to remove the upper end of the liftgate strut (2) from the ball stud on the liftgate.
5. Remove the liftgate strut from the vehicle.
Installation Procedure
1. Install the liftgate strut to the vehicle ball studs.
2. Push on the end of the strut in order to install the upper end of the liftgate strut (2) to the ball stud of the liftgate.
3. Push on the end of the strut in order to install the lower the end of the liftgate strut (1) to the ball stud on the body.
