Suburban 1/2 Ton 2WD V8-5.3L VIN T (2004)
Cupholder Replacement (Platinum)
Cupholder Replacement (Platinum)
Removal Procedure
1. Remove the console bezel assembly.
2. Remove the blower assembly.
3. Remove the four retaining screws.
4. Remove the plastic cover that the blower assembly slides into.
5. Slide the heat/cool unit from the front of the cup holder assembly.
Installation Procedure
1. Install the heat/cool unit in the cup holder assembly from the front of the assembly.
2. Install the plastic cover.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the four retaining screws.
Tighten the screws to 7 Nm (62 lb in).
4. Install the blower assembly.
5. Install the console bezel assembly to the console.
Cupholder Replacement - Front Seat
