Suburban 1/2 Ton 2WD V8-5.3L VIN T (2004)
Installation Procedure
1. Install the control rods to the assembly.
2. Connect the electrical connectors to the door lock actuator, if equipped
3. Install the door lock actuator to the door.
4. Connect the control rod to the outside door handle.
5. Connect the cylinder lock rod.
Notice: Refer to Fastener Notice in Service Precautions.
6. Install the bolts that retain the door lock actuator to the door.
Tighten the screws to 9 N.m (80 lb in).
7. Connect the manual door lock to the door retainer clips.
8. Connect the control rod for the inside door handle to the lock assembly (1).
9. Connect the inside door lock rod to the handle retainer clip.
10. Install the water deflector.
11. Install the door trim panel.
12. Inspect the operation of all the related components.
Lock Actuator Replacement - Rear Door
Lock Actuator Replacement - Rear Door
Removal Procedure
1. Raise the window.
2. Remove the door trim panel.
3. Remove the water deflector.