Suburban 1/2 Ton 2WD V8-5.3L VIN T (2004)
4. Disconnect the inside door lock rod from the handle retainer clip.
5. Disconnect the manual door lock rod from the door retainer clips.
6. Remove the rubber plug in order to disengage the outside handle rod retainer.
7. Disconnect the cylinder lock rod (1).
8. Remove the bolts (2) which retain the door lock actuator to the door.
9. Remove the door lock actuator and control rods as an assembly.
10. Disconnect the electrical connector from the door lock actuator, if equipped.
11. Remove the control rods as necessary.
Installation Procedure
1. Install the control rods to the assembly.
2. Connect the electrical connectors to the door lock actuator, if equipped.
3. Install the door lock actuator to the door.
4. Connect the outside door handle control rod.
5. Connect the cylinder lock rod.
Notice: Refer to Fastener Notice in Service Precautions.
6. Install the bolts which retain the door lock actuator to the door.
Tighten the screws to 9 N.m (80 lb in).
