Suburban 1/2 Ton 2WD V8-5.3L VIN T (2004)
Power Door Lock Switch: Procedures
Accessory Switch Replacement
ACCESSORY SWITCH REPLACEMENT
REMOVAL PROCEDURE
1. Remove the IP trim bezel.
2. Grasp the accessory switch assembly and pull outwards to remove the button assembly.
3. Disconnect the electrical connectors for the switches in the assembly.
4. Remove the switches and the button assembly.
INSTALLATION PROCEDURE
1. Connect the electrical connectors to the switches in the assembly
2. Install the accessory switch assembly into the IP till it snaps into place.
3. Install the IP trim bezel.
Switch Replacement - Door Lock and Side Window - Driver
SWITCH REPLACEMENT - DOOR LOCK AND SIDE WINDOW - DRIVER
REMOVAL PROCEDURE
