Suburban 1/2 Ton 2WD V8-5.3L VIN T (2004)
Memory Positioning Module: Customer Interest
Interior - Seat Memory Feature Appears Inoperative
Bulletin No.: 04-08-50-003
Date: February 26, 2004
INFORMATION
Subject:
Enabling Memory Seat Feature via DIC If Feature Appears Inoperative
Models:
2003-2004 Cadillac Escalade, Escalade ESV, Escalade EXT
2003-2004 Chevrolet Avalanche, Silverado, Suburban, Tahoe
2003-2004 GMC Sierra, Yukon, Yukon Denali, Yukon Denali XL
2003-2004 HUMMER H2
with Steering Wheel Controls (RPO UK3) (standard on H2)
If the memory seat feature appears inoperative, check the Driver Information Center (DIC).
Many of the memory seat modules that were returned through the Warranty Parts Center for a condition of inoperative have shown No Trouble Found.
The Driver Information Center (DIC), programmed for Seat Entry and Exit, is set to the default "Off" mode at the assembly plant. DO NOT REPLACE
THE MEMORY SEAT MODULE.
Perform the following procedure.
Important:
The following procedure will need to be completed for each Remote/Key selection.
Using the DIC menu, do the following steps:
1.
Set the "Seat Recall" to either "At Key In" or "On Remote" based on the customer's preference.
2.
Set the "Exit Seat" to "On".
3.
Adjust the following items:
Memory Seat:
3.1.
Driver's Seat (including the seat back, recliner, lumbar, and side wings)
3.2.
Throttle and Brake Pedals (not available on H2 or Silverado and Sierra Trucks)
3.3.
Outside Mirrors
3.4.
Radio Station Presets
3.5.
Last Chosen Climate Control System Settings (not available on Silverado or Sierra Trucks)
3.6.
Press and hold the "1" or "2" (for driver 1 or 2) button of the memory control for three seconds. A double chime will sound to let you know
that the position has been stored.
Easy Exit Seat:
3.1.
Press and release the 1 or 2 button or press the unlock button on the desired remote keyless entry transmitter. The seat will move to the
stored memory position.
3.2.
Adjust the seat to the desired exit position.
3.3.
Press and hold the exit button of the memory control (located on the door) for three seconds. A double chime will sound to let you know that
the position has been stored for the identified driver (1 or 2).
