Suburban 1/2 Ton 2WD V8-5.3L VIN T (2004)
pressure sensor, the seat cushion, and the control module are assembled and calibrated as a unit. Using only some of the components in the service kit
will cause the passenger presence system to operate improperly.
12. Remove the pad from the seat cushion frame.
13. Remove the seat cushion heater element, if equipped.
INSTALLATION PROCEDURE
1. Install the seat cushion heater element, if equipped.
2. Install the Inflatable Restraint Passenger Presence System.
3. Install the seat cushion pad to the seat cushion frame.
4. Using a side motion, carefully pull the seat cushion cover onto the frame pad.
5. Attach the seat trim cover to the seat cushion frame.
6. Install the lumbar actuator (5).
7. Install the seat switch bezel.
