Suburban 1/2 Ton 2WD V8-5.3L VIN T (2004)
8. Place the cushion on the rear plastic holders (1) on the underside of the seat cushion, and push rearward.
9. Connect the lumbar cable to the underside of the seat cushion (6). Connect the lumbar wire harness, if equipped with power lumbar.
10. Install the pressure sensor (2) to the front passenger seat frame, if equipped with the Inflatable Restraint Passenger Presence System.
11. Connect the electrical connectors.
Notice: Refer to Fastener Notice in Service Precautions.
12. Install the front nuts (2) onto the studs on the underside of the cushion.
Tighten the nuts to 21 N.m (15 lb ft).
13. Install the front seat trim panel.
14. Re-zero the Inflatable Restraint Passenger Presence System. Refer to Passenger Presence System Rezeroing Procedure in Restraint Systems. See:
Restraint Systems/Air Bag Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Related Tests and
Procedures/Passenger Presence System Rezeroing Procedure
