Suburban 1/2 Ton 2WD V8-5.3L VIN T (2004)
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to ___Nm (__lb in).
3. Install the floor console bezel.
Heated and Cooled Seat Switch Replacement (Rear-Platinum Models)
HEATED AND COOLED SEAT SWITCH REPLACEMENT (REAR-PLATINUM MODELS)
REMOVAL PROCEDURE
1. Insert a flat bladed tool on either side of the switch in order to pry outwards.
2. Pull the switch out to gain access to the wire connector.
3. Disconnect the wire connector.
INSTALLATION PROCEDURE
