Suburban 1/2 Ton 2WD V8-5.3L VIN T (2004)
7. Install the rear park brake cable end (2) to the park brake actuator lever (1).
8. Install the park brake cable to the mounting bracket (4) until the locking tabs snap into place.
9. Install the park brake cable to the equalizer bar by pulling down on the cable in front of the equalizer and installing the cable to the equalizer bar.
10. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
11. Remove the safety stands.
12. Lower vehicle.
13. Adjust the park brake. Refer to Park Brake Adjustment in Park Brake
Brake Rotor Refinishing
Brake Rotor Refinishing
Tools Required
^
J41013 Rotor Resurfacing Kit
^
J42450-A Wheel Hub Resurfacing Kit
Caution: Refer to Brake Dust in Service Precautions.
Important:
^
The disc brake rotors do not require refinishing as part of routine brake system service. New disc brake rotors do not require refinishing.
Do not refinish disc brake rotors in an attempt to correct the following conditions:
-
Brake system noise - squeal, growl, groan
-
Uneven and/or premature disc brake pad wear
-
Superficial or cosmetic corrosion/rust of the disc brake rotor friction surface
-
Scoring of the disc brake rotor friction surface less than the maximum allowable specification
^
Before refinishing a brake rotor, the rotor MUST first be checked for adequate thickness to allow the rotor to be refinished and remain above the
minimum allowable thickness after refinish specification. Refer to Brake Rotor Thickness Measurement.
Disc brake rotors should only be refinished if they have adequate thickness to be refinished and if one or more of the following conditions exist:
-
Thickness variation in excess of the maximum allowable specification
-
Excessive corrosion/rust and/or pitting
-
Cracks and/or heat spots
