Suburban 1/2 Ton 2WD V8-5.3L VIN T (2004)
8. Remove the brake hose to caliper bolt from the brake caliper.
9. Remove and discard the 2 copper brake hose gaskets. These gaskets may be stuck to the brake caliper housing or the brake hose end.
Installation Procedure
Important: Install 2 new copper brake hose gaskets.
1. Assemble the 2 new copper brake hose gaskets and the brake hose bolt to the brake hose.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the brake hose to caliper bolt and 2 new washers to the brake caliper.
Tighten the bolt to 40 Nm (30 ft. lbs.).
