Suburban 1/2 Ton 2WD V8-5.3L VIN T (2004)
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the nut to the threaded end of the intermediate cable.
Tighten the nut to 3.5 Nm (31 inch lbs.)
5. Remove the safety stands.
6. Lower the vehicle.
7. Adjust the park brake system. Refer to Park Brake Adjustment.
Park Brake Cable Mounting Bracket Replacement
Park Brake Cable Mounting Bracket Replacement
Removal Procedure
1. Release the parking brake.
2. Raise and support the vehicle. Refer to Vehicle Lifting..
3. Release the tension on the cables by loosening the nut at the equalizer.
4. Disconnect the rear cables from the equalizer.
5. Remove the rear cables from the mounting bracket by depressing the retaining tabs and pulling rearward.
6. Remove the cable support bracket nuts.
7. Remove the cable support bracket.
Installation Procedure
