Suburban 1/2 Ton 2WD V8-5.3L VIN T (2004)
1.
Install the gasket.
2.
Install the booster assembly.
3.
Install the 4 booster to bulkhead nuts.
Tighten
Tighten the nuts to 36 N.m (26 lb-ft).
4.
Snap the stop lamp switch onto the pushrod to the power brake booster.
5.
Install the stop lamp switch with the pushrod on the brake pedal pin.
6.
Install the brake switch retainer.
7.
Connect the electrical connector to the stop lamp switch.
8.
Install the master cylinder to the booster.
9.
Install the master cylinder mounting nuts.
Tighten
Tighten the nuts to 36 N.m (27 lb-ft).
10.
Connect the power brake booster outlet hose, the steering gear inlet hose, and the power brake booster inlet hose.
Tighten
^
Tighten the power brake booster inlet hose to 28 N.m (20 lb-ft).
^
Tighten the steering gear inlet hose to 28 N.m (20 lb-ft).
Important:
Maintain the fluid level throughout the bleed procedure.
11.
Remove the pump reservoir cap.
Important: