Suburban 1/2 Ton 2WD V8-5.3L VIN T (2004)
2. Install a NEW O-ring seal onto the oil level indicator tube, if required.
3. Install the oil level indicator tube between the exhaust manifold and engine block.
4. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
5. Install the oil level indicator tube into the block. The tube must be installed with the collar flush to the block.
6. Lower the vehicle.
Notice: Refer to Fastener Notice in Service Precautions.
7. Install the oil level indicator tube bolt
Tighten the bolt to 25 Nm (18 ft. lbs.).
8. Install the oil level indicator.
