Suburban 1/2 Ton 2WD V8-5.3L VIN T (2004)
7. With one end of the retaining clip engaged in the connector fitting slot, use your thumb in order to rotate the retaining clip around the connector
fitting, until the retaining clip snaps into place.
8. Ensure that the 3 retaining clip ears are seen from inside the fitting and that the retaining clip moves freely in the fitting slots.
9. Install a new retaining clip into the remaining quick connect fitting.
10. Install the pipe to the exhaust manifold.
11. Install the exhaust manifold pipe nuts.
Tighten the nuts to 50 Nm (37 ft. lbs.).
12. Lower the vehicle.
13. If equipped with a 6.0L engine, perform the following:
13.1.
Install the oil cooler hoses to the hose clip on the fan shroud.
13.2.
Snap the oil cooler hose clip shut.
