Suburban 1/2 Ton 2WD V8-5.3L VIN T (2004)
4. Install the Body Control Module.
5. Install the floor air outlet duct extension (1) to the floor air duct (2)
Mode Actuator Replacement - Auxiliary
MODE ACTUATOR REPLACEMENT - AUXILIARY
REMOVAL PROCEDURE
1. Remove the right rear quarter trim panel.
2. Disconnect the electrical connector from the mode actuator (1).
3. Remove the retaining screws from the mode actuator.
4. Remove the mode actuator (1) from the vehicle.
INSTALLATION PROCEDURE
1. Install the mode actuator (1) to the vehicle.
2. Install the screws to the mode actuator (1).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 1.6 N.m (14 lb in).
3. Connect the electrical connector to the mode actuator.
4. Install the right rear quarter trim panel.
Recirculation Actuator Replacement
RECIRCULATION ACTUATOR REPLACEMENT
