Suburban 1/2 Ton 2WD V8-5.3L VIN T (2004)
1. Install the new bulb to the headlamp assembly by twisting the bulb clockwise in order to lock in place.
IMPORTANT:
-
Replace a high beam bulb with another high beam bulb. The high beam bulb has a red gasket.
-
Replace a low beam bulb with another low beam bulb. The low beam bulb has a gray tip and a yellow gasket at the base.
2. Connect the electrical connector to the bulb.
3. Install the headlamp assembly.
4. Install the headlamp retainer pins.
5. Rotate inward and lock the pins in place.
6. Inspect the operation.
