Suburban 1/2 Ton 2WD V8-5.3L VIN T (2004)
Refrigerant Filter: Service and Repair
Air Conditioning (A/C) Refrigerant Filter Installation (With RPO Code C60)
AIR CONDITIONING (A/C) REFRIGERANT FILTER INSTALLATION (WITH RPO CODE C60)
TOOLS REQUIRED
J 39400-A Halogen Leak Detector
IMPORTANT: The A/C Refrigerant filter, ACDelco P/N 15-1696 must be installed to the A/C evaporator tube between the condenser and
evaporator.The installation of this A/C refrigerant filter eliminates the need for flushing.
1. Remove the air cleaner.
2. Measure 50 mm (2 in) from the bend on the evaporator tube (2) near the expansion tube end and mark the location.
3. Measure 50.8 mm (2 in) from the mark on the evaporator tube (2) from the previous step.
4. Using a tubing cutter, cut the marked section of the evaporator tube (2).
IMPORTANT: Do not allow metal burrs to enter the evaporator tube (2) during cutting or when removing the burrs.
5. Remove the burrs from the evaporator tube (2).
6. Remove the nuts (4), the ferrules (3), and the O-rings (2) from the A/C refrigerant filter (1).
7. Push the nuts (4) and ferrules (3) over each of the evaporator tube halves.
IMPORTANT: DO NOT install the O-rings (2) in this step.
8. Install the ferrules (3) with the small end toward the nut (4).
9. Install the A/C refrigerant filter (3) to the evaporator tube (2) with the flow arrow pointing towards the evaporator.
