Suburban 1/2 Ton 2WD V8-5.3L VIN T (2004)
6. Pull the quick connect fitting connection apart.
INSTALLATION PROCEDURE
1. Apply a few drops of clean engine oil to the male connection end.
CAUTION: In order to reduce the risk of fire and personal injury, before connecting fuel pipe fittings, always apply a few drops of clean
engine oil to the male pipe ends.
This will ensure proper reconnection and prevent a possible fuel leak.
During normal operation, the O-rings located in the female connector will swell and may prevent proper reconnection if not lubricated.
2. Push both sides of the quick-connect fitting together in order to cause the retaining tabs to snap into place.
3. Once installed, pull on both sides of the quick-connect fittings in order to make sure the connection is secure.
