Suburban 1/2 Ton 2WD V8-5.3L VIN T (2004)
7. Remove the control lever to the manual shaft nut.
3. Remove the control lever from the manual shaft.
9. Remove the PNP switch bolts.
10. Remove the PNP switch from the manual shaft. If the PNP switch does not slide off the manual shaft, file the outer edge of the manual shaft in
order to remove any burrs.
Installation Procedure
1. Install the PNP switch to the manual shaft by aligning the switch hub flats with the manual shaft flats.
2. Slide the PNP switch onto the manual shaft until the switch mounting bracket contacts the mounting bosses on the transmission.
Important: If a new PNP switch is being installed' the switch will come with a positive assurance bracket. The positive assurance bracket aligns
the new switch in its proper position for installation and the use of the park neutral switch aligner will not be necessary.
3. Install the PNP switch bolts finger tight.
