Suburban 1/2 Ton 2WD V8-5.3L VIN T (2004)
10. Remove the handle mounting screws (1).
11. Partially remove the seat cushion cover by separating the cushion trim J-strips.
12. Remove the bolts attaching the buckle to the seat cushion frame.
13. Remove the buckle and the latch from the seat frame.
Installation Procedure
1. Install the buckle and the latch to the seat frame.
2. Install the buckle bolts.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the bolts to 53 N.m (39 lb ft).
3. Connect the seat cushion cover by joining the cushion trim J-strips.
