Suburban 1/2 Ton 2WD V8-5.3L VIN T (2004)
5. Remove the bezel by pushing it through the fascia.
INSTALLATION PROCEDURE
1. Paint the new rear object sensor. Refer to basecoat/clearcoat paint systems in paint/coatings.
IMPORTANT: Do not refinish previously painted sensors. excess paint build up will cause the sensor to be inoperative.
2. check to make sure the paint does not exceed 6 mils. use a paint thickness gauge suitable for non-ferrous metals. refer to paint gages in
paint/coatings.
3. Paint the sensor bezel to match the color of the bumper fascia
4. Align the keyhole (2) with the key (1) and press the sensor bezel into the fascia.
