Suburban 1/2 Ton 2WD V8-5.3L VIN T (2004)
8. Push on the tabs (2) in order to lift the electrical center (1) out of the housing.
9. To replace the engine electrical center bracket remove the 4 retaining bolts (1).
10. Remove the engine electrical center bracket assembly from the fender.
INSTALLATION PROCEDURE
1. Install the engine electrical center bracket assembly to the front fender.
2. Install the 4 retaining bolts (1).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the 4 retaining bolts (1) to 9 N.m (80 lb in).
3. Align the electrical center block (1) stubs in the slots so that the tabs (2) retains it in place.
