Suburban 1/2 Ton 2WD V8-5.3L VIN T (2004)
Important: The bulbs in the steering wheel control switches are not serviceable. The switches should be replaced only as an assembly.
6. Remove the steering wheel control switch from the steering wheel.
Installation Procedure
1. Position the steering wheel control switch to the steering wheel.
2. Connect the electrical connector to the steering wheel control switch.
3. Install the steering wheel control switch into the steering wheel, ensuring the retaining tabs are fully seated.
4. Install the shroud to the steering wheel.
Notice: Refer to Fastener Notice in Cautions and Notices.
5. Install the shroud retaining screws to the steering wheel.
^
Tighten the screws to 2 Nm (18 inch lbs.).
6. Install the steering wheel.
