Suburban 1/2 Ton 2WD V8-5.3L VIN T (2004)
Suspension Strut / Shock Absorber: Service and Repair
Rear Shock Absorber
Shock Absorber Replacement (15 Series)
Removal Procedure
1. Raise and support the vehicle.
2. Disconnect the electrical connector and air line if equipped with electronic suspension control (ESC).
3. Support the rear axle.
4. Disconnect the ESC sensor, if equipped.
5. Remove the upper shock absorber nut and the bolt.
6. Remove the lower shock absorber nut and the bolt.
7. Remove the shock absorber.
Installation Procedure
