Suburban 1/2 Ton 2WD V8-5.3L VIN T (2004)
Torque Converter Clutch Solenoid: Service and Repair
Torque Converter Clutch Pulse Width Modulation (TCC PWM) Solenoid, TCC Solenoid, and Wiring Harness
^
Tools Required
-
J 28458 Seal Protector Retainer Installer
Removal Procedure
1. Remove the transmission filter.
2. Disconnect the transmission harness 20-way connector (1) from the transmission internal harness pass-through connector.
Depress both tabs on the connector and pull straight up; do not pry the connector.
Important: Removal of the valve body is not necessary for the following procedure.
3. Remove the 1-2 accumulator. Do not remove the spacer plate. Refer to Accumulator Assembly, Spacer Plate, and Gaskets.
4. Disconnect the internal wiring harness electrical connectors from the following components:
^
Transmission fluid pressure switch (1)
^
1-2 shift control solenoid (2)
^
2-3 shift control solenoid (3)
^
Pressure control solenoid (4)
^
Torque converter clutch pulse width modulation (TCC PWM) solenoid (5)
^
3-2 control solenoid (6)
