Suburban 1/2 Ton 2WD V8-5.3L VIN T (2004)
11. Install the valve body (5). Attach the manual valve to the detent lever while installing the valve body.
12. Install the transmission fluid pressure manual valve position switch (2).
13. Install the transmission fluid pressure manual valve position switch bolts (1) finger tight.
14. Tighten the bolts in the order shown.
^
Tighten the bolts to 11 Nm (97 inch lbs.).
15. Remove J 25025-5.
16. Install the manual shaft detent roller and spring (3) and bolts.
17. Install the 2 wiring harness clips (1) and bolts (2).
18. Install the wiring harness clip (1) and bolts (2).
19. Install the lube oil pipe (5) with the short end into the valve body.
20. Install the lube oil pipe retainer (7) and the bolt (6).
