Suburban 1/2 Ton 2WD V8-5.3L VIN Z Flex Fuel (2006)
Garnish Molding Replacement - Windshield Pillar
Garnish Molding Replacement - Windshield Pillar
Removal Procedure
1. Pull the molding straight out in order to release the retainers.
2. Disconnect the electrical connector.
3. Remove the windshield garnish molding.
Installation Procedure
1. Connect the electrical connector.
2. Ensure the bottom of the molding is seated in the slots on the I/P.
3. Align the molding retainers to the slots.
4. Press the moldings straight in till fully seated.
Trim Panel Replacement - Hinge Pillar
Trim Panel Replacement - Hinge Pillar
Removal Procedure
1. Remove door sill plate.
Installation Procedure
