Suburban 1/2 Ton 2WD V8-5.3L VIN Z Flex Fuel (2006)
5. Disconnect the manual door lock rod from the door retainer clips.
6. Remove the rubber plug (1) in order to disengage the outside handle rod retainer.
7. Disconnect the cylinder lock rod (1).
8. Remove the bolts (2) which retain the door lock actuator to the door.
9. Remove the door lock actuator and the control rods as an assembly.
10. Disconnect the electrical connector from the door lock actuator, if equipped.
11. Remove the control rods as necessary.
INSTALLATION PROCEDURE
1. Install the control rods to the assembly.
2. Connect the electrical connectors to the door lock actuator, if equipped
3. Install the door lock actuator to the door.
4. Connect the control rod to the outside door handle.
5. Connect the cylinder lock rod.
6. Install the bolts that retain the door lock actuator to the door.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 9 N.m (80 lb in).
7. Connect the manual door lock to the door retainer clips.
