Suburban 1/2 Ton 2WD V8-5.3L VIN Z Flex Fuel (2006)
1. Install the following components to the seat cushion frame:
-
The plastic retainers (3)
-
The frame suspension (2)
-
The frame springs (1)
2. Install the seat cushion trim cover and pad.
3. Install the seat trim panel.
4. Re-zero the inflatable restraint passenger presence system. Refer to Passenger Presence System Programming and Setup in Restraint Systems.
Seat Cushion Frame Replacement - Rear (Bench)
SEAT CUSHION FRAME REPLACEMENT - REAR (BENCH)
REMOVAL PROCEDURE
1. Remove the seat cushion and cover.
2. Remove the bolt (1) from the seat belt anchor.
3. Remove the bolt (2) from the hinge assembly.
4. Remove the seat cushion frame.
5. Transfer all necessary parts over to the new cushion frame.
INSTALLATION PROCEDURE
1. Install the seat cushion frame.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the bolt (2) to the hinge assembly.
Tighten the hinge bolt to 53 N.m (39 lb ft)
3. Install the bolt (1) to the seat belt anchor.
Tighten the seat belt anchor bolt to 53 N.m (39 lb ft)
4. Install the seat cushion and cover.
