Suburban 1/2 Ton 2WD V8-5.3L VIN Z Flex Fuel (2006)
2. Remove the power seat switch to bezel screws.
3. Remove the power seat switch.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Install the power seat switch to bezel screws.
Tighten the screws to 2 N.m (18 lb in).
2. Install the power seat switch bezel to the seat.
Seat Switch Bezel Replacement
SEAT SWITCH BEZEL REPLACEMENT
REMOVAL PROCEDURE
1. Remove the screws retaining the power seat switch bezel.
2. Disconnect the electrical connectors.
3. Remove the lumbar support switch.
4. Remove the power seat adjuster switch assembly.
INSTALLATION PROCEDURE
