Suburban 1/2 Ton 2WD V8-5.3L VIN Z Flex Fuel (2006)
1. Install the blower motor.
2. Install the blower motor to the heater/ventilation module. Turn the blower assembly clockwise until the retaining tab locks into place.
3. Install the blower motor insulating cover.
4. Connect the electrical connector to the blower motor.
5. Install the blower motor insulating cover screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 1.6 N.m (14 lb in).
6. If equipped, install the sound insulator panel.
Blower Motor Replacement (Visteon)
BLOWER MOTOR REPLACEMENT (VISTEON)
REMOVAL PROCEDURE
